Playground Surfacing in Southampton

Yes. Commercial Play installs playground surfacing throughout Southampton and the surrounding area. Every project starts with a free, no-obligation site visit, then a clear design and fixed quote.

Southampton is in one of the drier parts of the country, so schools get long outdoor seasons. The priority is a hard-wearing surface that copes with constant use, so we specify durable wet-pour and multi-use games markings that keep their colour under all-day play.

No. We work with schools across England & Wales from our Midlands and South offices, so we cover Southampton and Hampshire regularly as part of a wider service. You get a local, on-site team backed by our own installers.

Every surface we install is specified and tested to BS EN 1177 for its Critical Fall Height, so all are safe when correctly matched to the equipment above. Wet pour and rubber mulch reach the highest fall heights, up to the 3m playground maximum, when laid to the right depth over a compacted sub-base.

Indicatively, wet pour is around 29 to 90 pounds per square metre installed and rubber mulch about 40 to 100 pounds, with sub-base prep adding roughly 18 to 30 pounds where new groundworks are needed. These are market ranges to confirm against a site survey, as area, fall height and access all move the figure.

Both are porous bonded rubber. Wet pour gives a level, colourful, wheelchair-friendly finish for markings and graphics; rubber mulch gives a natural bark-effect look and reaches high fall heights for less per square metre, which suits tall equipment and woodland areas.

Wet pour runs from about 15mm up to 100mm or more, set by the Critical Fall Height. As a guide, roughly 25mm suits a 0.6m fall and about 100mm suits the 3m maximum, built as an EPDM wearing course of about 6mm over a deeper SBR shock base bound with polyurethane resin.

Yes, where the existing tarmac or macadam base is sound and level we can lay wet pour or a shock-pad system straight over it, which reduces groundworks and cost. We check the base on survey first, as a failing sub-base needs repair before any surfacing goes down.

Rubber mulch gives a similar natural look but does not rot, blow away or need annual topping up, and it holds a higher, more consistent Critical Fall Height. Loose bark and wood chip decompose and must be replenished, so bonded rubber mulch usually works out better over its life.

Wet pour and rubber mulch need little more than occasional brushing and clearing of leaves and debris, plus a check of the wearing course. We repair splits, worn patches and edges as they appear so small issues do not spread; see repairs and maintenance.

Timescales depend on area and groundworks, but the affected zone is fenced off while we work and while the wet pour polyurethane binder cures. We phase larger jobs where we can so part of the space stays open, and we confirm the programme on quote.

Wet pour and rubber mulch use EPDM and SBR rubber granules bound with polyurethane and are widely used across UK schools under BS EN 1177. Rubber mulch is made from shredded recycled tyre, which also gives it a recycled-content and sustainability benefit.

Yes. Wet pour takes colour graphics and markings in the EPDM surface itself, and we also apply thermoplastic games and designs; see thermoplastic playground markings. For courts and pitches, see MUGA sports surfacing.